Human Touch iJOY-300 Manual

next previous

Please send any questions or comments regarding these instructions to: documentation@humantouch.com

, LLC.

INSTALLING THE NEW REMOTE

1. Holding the new remote next to the chair base, connect the remote connectors to the corresponding connectors on the chair base.

2. Using a flat-head screwdriver and screw, attach the green grounding wire to the chair using the threaded screw hole as shown.

3. Place the remote cable into position, then replace the plastic remote cable grommet to hold the cable in place.

4. Replace the four screws to secure the cable cover.

5. Replace the metal plate, then secure it using the four screws.

6. Position the power panel firmly into place, then secure it using the four screws.

7. Tip the chair gently back to an upright position.

8. Plug in the chair and power it on.

9. Verify that the chair is now receiving power and that the remote control is working properly.