INSTALLING THE NEW FOOT AND CALF MASSAGER
1. Place the new foot and calf massager into position, then insert pin A just far enough into the left side of bracket A to hold it in place.
2. Line up the actuator bracket with the mounting point on Bracket A, then push the pin through the bracket as far as it will go by hand.
3. Line up the left side of the massager with Bracket B, then insert Pin B through the bracket as far as it will go by hand.
4. Use a small hammer to push both pins until the pin heads are flush with the bracket.
5. Replace the two brackets on the front of the massager frame and secure them using a Phillips-head screwdriver and two screws.
6. Lift the massager up, then insert a box or other sturdy object beneath it for support.
7. Reconnect the red connectors on the lower left-hand side of the backrest.
8. Replace the connector box cover and secure it, using a Phillips-head screwdriver and two screws.
9. Place the air pump into position, then secure it with the six sets of screws/washers.
10. Install new zip ties to replace those you removed earlier, to secure the massager cabling to the chair base, out of sight.
11. Reinstall the upholstered flap, by wrapping it around the massager frame and securing it using the hook and loop fasteners.
Pin B
Pin A
Brackets
Bracket B
Bracket A
Pin A
Bracket A
Actuator bracket
Actuator bracket
3
Please send any questions or comments regarding these instructions to: documentation@humantouch.com
© 2012 Human Touch
®
, LLC.
