A SERVICE OF

logo

Open as PDF
next previous
“C” clip
2
7. Using a Phillips-head screwdriver, remove the two screws from the bracket that secures the actuator shaft (Fig.4).
8. Using a 6-mm Allen wrench, remove the two Allen bolts that secure the white sensor housing to the calf massager deployment mechanism (Fig.5).
9. Using a small flat-head screwdriver, remove the “C” clip from the hinge pin that secures the actuator to the chair frame (Fig.6).
10. Remove the hinge pin, then remove the actuator from the chair (Fig.7).
(Fig.4)
Actuator shaft
Allen bolt
(Fig.5)
(Fig.6)
Hinge pin
Actuator
(Fig.7)
Allen bolt
White sensor