The SYSTEMS MONITOR
telh
you if
certiin
things are wrong
DISPLAY
WHAT IT MEANS WHAT TO DO
I:/#:
Electrical power has been
IF DISHWASHER WAS IN USE WHEN THE POWER
;n$
interrupted to the dishwasher but
FAILURE OCCURRED:
RESET
is now back on.
1. Unlatch the door. If the detergent cup is open, add
detergent and close the cup.
2.
Relatch
the door and touch “START” then immediately
touch “CLEAR/RESET?’ (This will pump any remaining
water out of the machine. )
3. Select the desired cycle and rerun the load.
IF DISHWASHER WAS
NOT
IN USE:
1. Latch door.
2. Select desired cycle.
3. Run cycle when desired.
CUP OPEN
The detergent cup was open at the 1. Unlatch the door and add detergent if spilled.
start of a cycle.
2. Close cup.
3. Latch door and select cycle.
4. Touch
“START:’
NOTE:
If cup is latched properly and “CUP OPEN” repeats you
may start wash cycle by pressing START pad a second time.
BLOCKED
An obstruction is preventing the
1. Unlatch door.
WASH ARM
lower wash arm from turning.
This is usually caused by a utensil
2. Check the lower rack for any item that could block the
wash arm and reposition it.
sticking through the bottom of the
silverware basket or a pot handle
3.
Relatch
door.
through the lower rack.
NOTE:
If the wash arm is not blocked and “BLOCKED WASH
ARM” display still appears, you may start wash cycle by
pressing START pad a second time.
BLOCKED
The dishwasher is taking longer
This dishwasher is designed to automatically compensate
DRAIN
than normal to drain the water
for longer than normal drain times, but cycle time will be
out. This is usually caused by a extended. If this code continues to appear frequently then:
blockage in the drain air gap (see
1. Clean the air gap (see page 21).
page 21), a kink in the drain hose,
or a stopped up drain pipe.
2. Check for a kink in the drain hose.
3. Check plumbing for slow or stopped up drains.
(NOTE: Warranty service does not cover household
drain problems. )
8
