TM 11-6625-2965-14&P
SECTION II
INSTALLATION
2-1 INITIAL INSPECTION
2-2 Before shipment, this instrument was in-
spected and found to be free of mechanical and
electrical defects. As soon as the instrument is
unpacked,
inspect for any damage that may have
occurred in transit. Save all packing materials
until the inspection is completed. If damage is
found, a claim should be filed with the carrier.
Hewlett-Packard Sales and Service office should
be notified.
2-3 MECHANICAL CHECK
2-4 This check should confirm that there are no
broken knobs or connectors, that the cabinet and
panel surfaces are free of dents and scratches,
and that the meter is not scratched or cracked.
2-5
ELECTRICAL CHECK
2-6 The instrument should be checked against its
electrical specifications. Section V includes an
“ in-cabinet” performance check to verify proper
instrument operation,
2-7 INSTALLATION DATA
2-8 The instrument is shipped ready for bench
operation. It is necessary only to connect the in-
strument to a source of power and it is ready for
operation.
2-9 LOCATION
2-10 This instrument is air cooled. Sufficient
space should be allotted so that a free flow of
cooling air can reach the sides and rear of the in-
strument when it is in operation. It should be used
in an area where the ambient temperature does not
exceed 50°C.
2-11 OUTLINE DIAGRAM
2-12 Figure 2-1 is an outline diagram showing the
dimensions of the instrument.
2-13 RACK MOUNTING
2-14 This instrument may be rack mounted in a
standard 19 inch rack panel either alongside a
similar unit or by itself. Figures 2-2 and 2-3 show
Figure 2-1. Outline Diagram
how both types of installations are accomplished.
2-15 To mount two units side-by-side, proceed
as follows:
a. Remove the four screws from the front
panels of both units.
b. Slide rack mounting ears between the
front panel and case of each unit.
c. Slide combining strip between the front
panels and cases of the two units.
d. After fastening rear portions of units to-
gether using the bolt, nut, and spacer, replace
panel screws.
2-16 To mount a single unit in the rack panel,
proceed as follows:
a. Bolt rack mounting ears, combining
straps, and angle brackets to each side of center
2-1
