KK-XXX-05_INST_8-07
4
Ford Van Driver-Side rear Ford Van Passenger-Side rear
PASSENGER WINDOW VAN PREPARATIONS:
1. Remove all rear bench seats from the vehicle.
2. Modify / remove interior parts as needed.
3. Remove floor mat/carpet and replace with ½” plywood or sound deadening material.
(Recommended).
4. If installing KK-F-VAK, (OEM air conditioning adapter) cut or remove all plastic
trim around the rear OEM system.
8”inches to rear body flange. Note: The OEM rear Black
plastic trim will remain. Photos show without Trim.
8” to 8 ½” Note: Exact position may not be
square to Driver side if van has OEM rear Air
conditioning
Note: Photos above show a Chevrolet Van. Photos are intended to show rubber floor mat option only.
***Kwik kits are designed for cargo vans with no rear OEM trim, however they can be
installed into passenger window vans. Some rear trim removal or modification is required.
o not remove a
l rear trim and headliner as this will aid in sound deadenin
& insulation
UNPACKING AND INSTALLATION:
***Refer to exploded view drawing on page 16 to identify parts ***
