M0412a-0920
10
ASSEMBLY
F
M0412a-0920
6
7
4
• Fit the tabs on the left footboard into the slots in the left side
of the vehicle frame. Make sure both tabs are in the slots.
Hint: You may need to squeeze the left footboard in order to
align the tabs with the slots.
• Insert two #8 x
3
/4" screws into the left footboard and tighten.
Left
Footboard
Tab
Tab
Slots
5
• The right footboard was inserted in the vehicle frame at
the factory. Make sure the right footboard is in place.
• Insert two #8 x
3
/4" screws into the right footboard
and tighten.
Right
Footboard
Vehicle
Frame
• Separate the exhaust set pieces. Note the R (right side) and L
(left side) markings on the inside of each piece.
• Fit the inner half of the right exhaust pipe (R) over the stabilizer
wheel on the right side of the vehicle. Make sure the peg on the
inner exhaust pipe fits into the hole in the vehicle body.
Vehicle Frame
(Right Side)
Stabilizer
Wheel
Vehicle
Body Hole
Right Exhaust
Pipe - Inner Half
Peg
Hint: Use a long-shafted Phillips screwdriver to complete this
assembly step.
• Align the holes in the inner half of the right exhaust pipe with
the holes in the vehicle frame.
• Insert four #8 x
3
/4" screws through the inner half of the right
exhaust pipe and into the vehicle frame. Tighten the screws.
IMPORTANT! The screw marked with an asterisk
*
in the illustration
above must go through the hole in the inner half of the right exhaust
pipe, the vehicle body and into the vehicle frame. Make sure all the
holes are properly aligned and the screw goes through all three parts.
Vehicle
Frame
Right Exhaust
Pipe - Inner Half
Left Side View
Right Side View
*
