10 11
ASSEMBLY INSTRUCTION
ASSEMBLE AS A MULCHER
1. Slide the front and rear mulcher tubes together until the lock button engages. (See g 2)
2. Pull the lock button forward to disengage the gate. Hold the gate open. (See g 2.1)
3. Insert the “wedged” end clip of the mulcher tube into the rear clip. (See fig 2.2). Push the
“hooked” end clip of the mulcher tube into the front clip. (See g 2.3). Press the lock button back
to engage the mulcher tube. (See g 2.4)
4. To remove mulcher tubes, follow the steps (3) (2) (1).
5. Insert the bag adaptor into the blower outlet. Lock the bag adaptor with the lock button. To re-
move the bag, simply press lock button and remove bag. (see Fig.4).
WARNING
To prevent serious personal injury, make sure the switch is in the OFF position, it is unplugged, and
the impellers have stopped before attaching or removing tubes.
⑤
④
②
③
NOTE: It may be necessary to remove the blower tube or mulcher tubes to clear a blocked tube or impeller.
(See Fig. 2)
Fig.2
Fig.2.1 Fig.2.3
Fig.2.4
Fig.2.2
Fig.2.5
①
ASSEMBLY INSTRUCTION
ASSEMBLE AS A BLOWER ((See Fig. 3))
1. Slide blower tube forward until the notched areas on the blower housing click into the slots on
the tube.
2. Insert the concentrator nozzle into the regular nozzle to lock. (Concentrator nozzle is used to-
increase air ow in tight areas: ower beds. under decks, etc.).
INSTALLING BAG WITH SHOULDER HARNESS (See Fig.4)
While standing in the operating position adjust the length to t the operator’s size. Pull the tab to
lengthen, pull the strap to shorten.
Fig. 3
Fig. 4
SLOT
BLOWER
TUBE
CONCENTRATOR
NOZZLE
NOTCHED
AREA
AIR
OUTLET
PUSH
INSERT
PUSH
OUT
Lock button
TAB
STRAP
