15
CHANGING THE FILTER
Ordering Replacement Filters
Toorderyourreplacementlters,pleasevisitouronline
store at www.frigidaire.com/store, by calling toll-free
at 877-808-4195, or by visiting the dealer where you
purchased your refrigerator. Frigidaire recommends that you
orderextralterswhenyourstinstallyourrefrigerator,and
thatyoureplaceyourltersatleastonceeverysixmonths.
Water Filter
Thewaterlterislocatedatthetoprightsideofthefresh
food compartment.
Replacing the Water Filter
Ingeneral,youshouldchangethewaterltereverysix
months to ensure the highest possible water quality. Water
Filter Status on the user interface prompts you to replace
thelterafterastandardamountofwater(200gallons/757
liters for PureSource 3
TM
)
hasowedthroughthesystem.
If your refrigerator has not been used for a period of time
(duringmovingforexample),changethelterbefore
reinstalling the refrigerator.
Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after
thesystem.Systemscertiedforcystreductionmaybeused
ondisinfectedwatersthatmaycontainlterablecysts.
Test & certication results:
• RatedCapacity-200gallons/757litersfor
PureSource 3
TM
iceandwaterlter
• Ratedserviceow-.50gallonsperminute
• OperatingTemp.:Min.33°F,Max.100°F
• MaximumRatedPressure-100poundspersquareinch
• RecommendedMinimumOperatingPressure:30
pounds per square inch
To replace your PureSource 3
TM
water lter:
It is not necessary to turn the water supply off to change
thelter.Bereadytowipeupanysmallamountsofwater
releasedduringthelterreplacement.
1 Turn Off the ice maker.
2 Removethelterbypushingontheend/faceofthe
lter.
3 Slidetheoldwaterltercartridgestraightoutofthe
housing and discard it.
4 Unpackagethenewltercartridge.Usingthe
alignmentguide,slideitgentlyintothelterhousing
until it stops against the snap-in connector at the
back of the housing.
5 Push rmly until the cartridge snaps into
place (you should hear a click as the cartridge
engages the snap-in connector).
6 Press a drinking glass against the water dispenser
whilecheckingforanyleaksatthelterhousing.
Any spurts and sputters that occur as the system
purges air out of the dispenser system are normal.
7 Afterllingoneglassofwater,continueushingthe
system for about four minutes.
8 Turn On the ice maker.
9 Press and hold the Water Filter button on the Ice
& Water Dispenser control panel for three seconds.
When the display changes from Red to Green, the
status has been reset.
The PureSource 3
TM
iceandwaterlter
systemistestedandcertiedtoNSF/ANSI
Standards 42 and 53 for the reduction of claims
speciedontheperformancedatasheet.
More about your Advanced Water Filter
Air Filter (some models)
Theairlterislocatedatthetopofthefreshfood
compartmentnexttothewaterlter.
Replacing the Air Filter
Ingeneral,youshouldchangetheairltereverysix
months(thelterstatuslightonthecontrolpanelprompts
youtoreplacethelteraftersixmonths)toensureoptimal
lteringofrefrigeratorodors.Youmaywanttoadjustthis
time period depending on the types and amounts of food
you typically store in your refrigerator. To replace you
PureSource Ultra
TM
airlter:
1 Pulltheairlterhousingstraightout.
2 Removetheoldlteranddiscardit.
3 Unpackthenewlterandplaceitinsidethehousing.
4 Slide the housing back into position.
Here is the product number to request when ordering:
PureSource 3
TM
Water Filter
Part #WF3CB
PureSource Ultra
TM
Air Filter
Part #PAULTRA