Specications
– Unlatching position: Deck does not latch at
the transport position.
Seat
• Type: Standard seat with foam padded seat
cushion with armrests and integral safety switch.
Optional seat: Seat with high back, extra
wide foam padded seat cushion with internal
suspension, thick bolstering, two-tone cover,
armrests, integral safety switch, and seat vibration
isolation system.
Optional seat accessories for units with standard
seats:
– Custom ride suspension system to enhance
Standard Seat. Adds approximately 3 inches
(7.6 cm) to seat height.
– Deluxe suspension seat with high back, low
prole foam-in-place cushion (dampened,
adjustable spring suspension), armrests, and
integral safety switch. Seat height remains the
same.
– Seat Isolation System for reduced vibration,
to enhance ride of standard seat, standard seat
with Custom Ride Seat Suspension or Deluxe
Suspension Seat. Adds approximately 1 inch
(2.5 cm) to seat height.
• Mounting: Adjustable fore and aft on seat tracks.
• Armrests: Molded ip-up armrests.
• Seat Safety Switch:
Integrated seat switch. Time delay seat switch
eliminates rough ground cut-outs.
Hydrostatic Ground Drive System
• Two unitized hydrostatic transmissions:
12cc Parker axial piston pump
240cc Parker geroler motor
• Hydraulic Oil Type: Exmark Premium Hydro oil.
• Hydraulic Oil Capacity: 52 oz (1.5 L) per side
• Hydraulic Filter: P/N 116-0164
• Speeds:
– 0-8 mph (12.9 km/hr) forward.
– 0-4.5 mph (7.2 km/hr) reverse.
• Drive wheel release valves allow machine to be
moved when engine is not running.
Tires & Wheels
Drive
Pneumatic (Air lled)
Deck Size
48 & 52
Quantity
2
Tread
Turf Master
Size 22 x 9.50-12
Ply Rating
4
Pressure
13 psi (90 kPa)
Front Caster
Pneumatic (Air lled)
Deck Size
48 & 52
Quantity
2
Tread
Smooth
Size 12 x 5.00-6
Ply Rating
4
Pressure
13 psi (90 kPa)
Cutting Deck
• Cutting Width:
– 48 inch Deck: (121.9 cm)
– 52 inch Deck: (132.1 cm)
• Discharge: Side
• Blade Size: (3 ea.)
– 48 inch Deck: 16.25 inches (41.3 cm)
– 52 inch Deck: 18.00 inches (45.7 cm)
• Blade Spindles: Solid steel spindles with 1.00 inch
(25 mm) I.D. bearings.
• Deck Drive: “B” Section belt with self-tensioning
idler.
• Electric clutch: 175 ft-lb Mag Stop
• Deck: Full oating deck is attached to out-front
support frame. Anti-scalp rollers provide
maximum turf protection. Deck design allows for
bagging, mulching or side discharge.
– 48 inch Deck: 3 anti-scalp rollers
– 52 inch Deck: 3 anti-scalp rollers
• Deck Depth:
– 48 inch Deck: 5.5 inches (14 cm)
– 52 inch Deck: 5.5 inches (14 cm)
16
