43
WARNING
• When installing wall mounts on cinder block, verify that you have a minimum of 1-3/8”
of actual concrete thickness in the hole to be used for the concrete anchors. Do not drill
into mortar joints! Be sure to mount in a solid part of the block, generally 1” minimum
from the side of the block. It is suggested slow setting is used to drill the
hole instead of a hammer drill to avoid breaking out the back of the hole when entering
a void or cavity.
• Installer must verify that the supporting surface will safely support the combined load of
the equipment and all attached hardware and components.
to use a
1b
SOLID BRICK AND CONCRETE BLOCK MOUNTING:
• Use the wall plate as a template to mark four holes locations on the wall as shown in fig.1.2.
• Pre-drill these holes with an 8mm masonry bit to at least 50mm in depth. Insert a Concrete Anchor (P-B) into
each of these holes. Attach the wall plate to the wall using four screws (P-A), make sure that the wall plate is level
as shown in fig.1.2.
fig.1.2
WOOD STUD WALL MOUNTING:
1a
WARNING
• Make sure that the supporting surface will safely support the combined load of the
equipment and all attached hardware and components.
• Tighten wood screws firmly, but do not over tighten. Over tightening can damage
the screws, greatly reducing their holding power.
• Make sure that mounting screws are anchored into the center of the studs. Use of
an “edge to edge” stud finder is highly recommended.
• Hardware provided is for attachment of mount through standard thickness drywall
or plaster into studs. Installers are responsible to provide hardware for other types
of mounting situations.
• Use a stud finder to locate the edges of the studs. Use of an edge-to-edge stud finder is highly recommended.
Based on their edges, draw a vertical line down each stud’s center.
• Place wall plate on wall as a template. And mark the center of the four mounting holes. Make sure that the
mounting holes are on the stud centerline.
• Drill four 1/8” (3mm) dia. Holes 1.2” (30mm) deep. Secure it using four screws (P-A), make sure that the wall
plate is level as shown in fig. 1.1.
fig.1.1
stud
P-A
P-A
P-B
