26
1
2
3
4
5
6
7
8
9
10
11
Image Memory
Images can be stored / called in the memory of this
product (max. 8 images).
1. Press the [IMAGE
.
SET] button on the wireless
remote control and press the MEMORY NO.
button of the wireless remote control within 4 sec
then the image is stored in the pressed number.
When the Power Supply is turned OFF by pressing
the [POWER] button of the wireless remote
control, the images stored in the memory are
deleted.
2. How to read out stored images
Press the [IMAGE
.
CALL] button on the wireless
remote control and press the MEMORY NO. button
of the wireless remote control within 4 sec then the
image in the memory corresponding to the pressed
number is read out.
To return to the normal camera image, press the
[IMAGE
.
CALL] button again “within 4 seconds”.
The image cannot be saved in the number from
which the image is read.
"Utility Software CD-ROM"
The attached "Utility Software CD-ROM" contains the PC link software "Image Mate" and the
TWAIN driver "ELMO TWAIN DS, "and can be operated as shown below.
• To transfer graphic data to PC.
• To operate this product by PC.
For details, see the Installation Manual for "Utility Software" and "manual.pdf" in the CD-
ROM.
F.A.M.
