26 se c t i O n 6— Ma i n t e n a n c e & ad j u s t M e n t s
Emptying the fuel system:c.
fuel consumption with the goal of running
the fuel tank empty.
Close the fuel tank shutoff valve. Disconnect
the fuel line from the carburetor and put the
end into an approved fuel container.
fuel tank and line into the approved container.
Reinstall the fuel line on the carburetor.
This will prevent gum and varnish deposits
from forming. Replace the fuel filter.
Remove the spark plugs and pour approximately one
ounce of oil into each cylinder. Crank the engine one or
two turns to spread the oil evenly on the cylinder walls.
Replace the spark plugs.
Clean the engine and the entire tractor thoroughly.4.
NOTE: Use of a pressure washer or garden hose is not
recommended to clean your tractor. They may cause
damage to electrical components, spindles, pulleys,
bearings or the engine. The use of water will result in
shortened life and reduce serviceability.
5.
when needed.
6.
oil on any unpainted surfaces including the pulleys and
Clean and fully charge the battery, then disconnect the 7.
negative cable at the battery to prevent possible discharge.
Recharge the battery periodically when in storage.
NOTE: Remove the battery if exposed to prolonged periods
where temperatures are above freezing.
Lubricate all lubrication points.8.
off of the tires.
Removing The Tractor From Storage
Check the engine oil.
Fully charge the battery, lower tractor off blocks, and 2.
inflate the tires to the recommended pressure.
Remove the spark plugs and wipe them off. Using the
starter, crank the engine to pump the excess oil out of the
spark plug holes. Replace the spark plugs and the ignition
leads.
If drained before storing, fill the fuel tank with clean, fresh 4.
gasoline.
Check the level of the engine oil in the crankcase and the 5.
hydraulic reservoir tank.
6.
ensure engine is operating properly.
Drive the tractor without a load to make certain all the 7.
tractor systems are functioning properly.
Adjustments
Seat Position Adjustment Lever
To adjust the position of the seat, pull up and hold the seat
desired position; then release the adjustment lever. Make sure
6-4.
Weight Adjustment Lever
The weight adjustment lever is located on the right side of the
Seatback Recline Knob
The seatback recline knob is located on the right side between
the seat back and seat bottom. Turning it clockwise adds
Adjusting RH & LH Drive Control Levers
control lever and seat adjustment will result in the following:
In the neutral position with hands on the control levers,
approximately vertical.
In the full forward position,
In the full reverse position,
torso.
Figure 6-4
