UGH004/0999 microKool Portable Chillers
TROUBLESHOOTING 6-15
REPLACING THE
MOTHERBOARD
IMPORTANT:
Always
refer to the wiring dia-
grams that came with
your chiller to locate spe-
cific electrical compo-
nents. Illustrations in the
User Guide are intended
to be representative only.
Disconnect and lockout the main power supply.
Open the electrical enclosure door.
Turn the screw
on the front panel counterclockwise to open.
Mark or label each wire
connected to the mother-
board.
The orange shield is
labeled with the connection
information. You must label the
wires to ensure they are con-
nected to the correct terminals
on the new motherboard.
Disconnect the wires
from the motherboard by
pulling the terminal
blocks up.
Loosen the screws hold-
ing the orange shield.
Remove the mother-
board and shield
from the
electrical enclosure as a unit.
Remove the mother-
board from the shield
and replace with the new
motherboard.
Reattach the shield and
new motherboard
in the
electrical enclosure. Tighten
the screws.
Reconnect the terminal
blocks and wires to the
new board.
Make sure you align the terminal blocks with the correct
pins on the board. Push the terminal blocks onto the pins,
taking care not to bend any pins.
Set dip switches 7 and 8 to the correct unit type.
Set switch 7 to ON and switch 8 to OFF for chillers.
Program output monitors on the new board.
See
D
ISABLING OR
E
NABLING
O
UTPUT
M
ONITORS
in the
M
AINTENANCE
section.
1
2
3
4
5
6
