Page 9For technical questions, please call 1-800-444-3353.SKU 91938
OPERATING INSTRUCTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set up
or use of this product.
Tool Set Up
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION:
Release the Trigger, unplug the
tool from its electrical outlet and
allow the wheel to cool
completely before performing
any inspection, maintenance, or
cleaning procedures.
To Remove or Install a Cut-Off Wheel
Raise the Saw if it is locked down by 1.
pushing down on it and pulling out the
Lock Ball (25).
Open the Swing Guard (53) and tighten 2.
the Bolt (112) to secure it while working
on the Wheel.
FIGURE 1
Lock Pin
(63)
Fixed
Guard (60)
Handle
3. Push the Lock Pin (63) towards the
Fixed Guard (60) as shown in FIGURE
1. Rotate the wheel until the Lock Pin
(63) slides into place.
FIGURE 2
Lock
Pin (63)
Hex Key
(111a)
Socket Head
Bolt (54)
4. While continuing to hold down the Lock
Pin (63), use the Hex Key (111a) to
loosen the Socket Head Bolt (54). See
FIGURE 2.
Remove the Socket Head Bolt (54), the 5.
Flange Washer (96), the Outer Flange
(55), and the Cut-Off Wheel (56).
Socket Head
Bolt (54)
Flange
Washer (96)
Outer
Flange (55)
Cut-off Wheel (56)
Inner Flange (57)
6. Replace with a new Cut-Off Wheel (56),
and reassemble the parts listed above
in number 3. The concave side of the
Outer Flange (55) must face the wheel.
While holding the Lock Pin (63), tighten
the Socket Head Bolt (54) with the Hex
Key (111a).
