UtNISTALLATilON STEP 7
Install the Battery Backup
- Make sure motor unit is unplugged.
• Using a Phillips head screwdriver, remove the battery
cover on the motor unit.,
• Partially insert battery into motor unit with terminals
facing out.
• Connect the red (+) and black (-) wires from motor unit
to corresponding terminals on battery.
• Replace battery cover.,
;:i;::ii :::i:::i _::b'::::¸ ....
ALWAYSwear protectivegtovesand eyeprotectionwhen
changingthebatteryor working aroundthe battery
compartment.
Batten]
Battery Cover
gNSTALLATIION STEP 8
Nnstali the Lights
• Press the release tabs on both sides of lens..Gently
rotate lens back and downward until the lens hinge is in
the fully open position.. Do not remove the lens..
• Install a 100 watt maximum light bulb in each socket.
Light bulb size should be A19, standard neck only.,The
lights wilt turn ON and remain lit for approximately
4-1/2 minutes when power is connected_ Then the lights
will turn OFF,.
° Reverse the procedure to close the lens.,
o Llse A19, standard neck garage door opener bulbs for
replacement,
NOTE: Use only standard light bulbs,. The use of short
neck or speciality light bulbs may overheat the endpanel
or light socket°
To preventpossibleOVERHEATINGof the endpanelor light
socket:
o DONOTuseshort neck or specialtylight bulbs,.
• DONOTusehalogenbulbs,,UseONLYincandescent,
To preventdamageto the opener:
• DONOTusebulbs largerthan IOOW.
• ONLYuseA19 sizebulbs
!oo Watt (Max)
Standard Light Bul_
/
Release Tab
I
1O0Walt (Max) Hinge
Standard Ught Bulb
18
