Cover C
GETTING READYCONTENTS SEWING BASICS UTILITY STITCHES APPENDIX INDEX
Needle and presser foot
section
a Buttonhole lever
Lower the buttonhole lever when sewing buttonholes
and bar tacks.
b Thread guide discs
Pass the thread through the thread guide discs when
using the needle threader to thread the needle.
c Needle bar thread hook
Pass the upper thread through the needle bar thread
hook.
d Needle plate
The needle plate is marked with guides for sewing
straight seams.
e Bobbin cover/Shuttle
Remove the bobbin cover, and then insert the bobbin
into the shuttle.
f Feed dogs
The feed dogs feed the fabric in the sewing direction.
g Presser foot
The presser foot applies pressure consistently on the
fabric as the sewing takes place. Attach the appropriate
presser foot for the selected stitching.
h Presser foot holder
The presser foot is installed onto the presser foot holder.
Right-side/rear view
a Presser foot dial
Use the presser foot dial to adjust the amount of
pressure that the presser foot applies to the fabric.
b Handle
Carry the sewing machine by its handle when
transporting the machine.
c Balance wheel
Turn the balance wheel toward you to raise and lower
the needle to sew one stitch.
d Air vent
The air vent allows the air surrounding the motor to be
exchanged. Do not cover the air vent while the sewing
machine is being used.
e Main power switch
Use the main power switch to turn the sewing machine
on and off.
f Foot controller jack
Insert the plug on the end of the foot controller cable
into the foot controller jack.
g Power supply jack
Insert the plug on the power supply cord into the power
supply jack.
h Feed dog position switch
Use the feed dog position switch to lower the feed dogs.
Memo
z Refer to Cover B, D or E pages while you are
learning to use your machine.
1
2
3
4
5
6
7
8
2
3
5
6
4
7
8
1
