UPGRADING YOUR MACHINE’S SOFTWARE
Appendix
189
8
UPGRADING YOUR MACHINE’S SOFTWARE
You can use a computer to download software upgrades for your sewing machine.
a
While holding the “Presser Foot Lifter” button
pressed, turn on the machine.
→ The following screen appears.
b
Plug the USB cable connectors into the
corresponding USB ports on the computer
and on the machine.
→ The “Removable Disk” icon appears in “My
Computer” on the computer.
c
Copy the upgrade file to “Removable Disk”.
→ The message “Connected to PC. Do not disconnect
the USB cable.” appears.
d
When the screen shown in step a appears
again, press .
→ The message “Saving the upgrade file. Do not turn
main power to OFF.”appears. The download takes
about 3 minutes.
e
When the following screen appears, the first
upgrade file is downloaded.
f
Copy the second upgrade file to “Removable
Disk”.
g
When the screen shown in step a appears
again, press .
→ The message “Saving the upgrade file. Do not turn
main power to OFF.”appears. The download takes
about 3 minutes.
Note
There are two upgrade files. Be sure to download both files successively.
Memo
• When the machine’s software is upgraded, saved combinations of character and decorative stitches are erased.
However, saved embroidery patterns are not erased.
• While the software is being upgraded, the buzzer will not sound when a key is pressed.
Press LOAD after saving the
upgrade file in the
machine.
Press LOAD after saving the
upgrade file in the
machine.
