66
EMBROIDERY — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Connecting character patterns
If the character pattern is too long to fit in the
embroidery frame, follow the steps below.
Example: Connecting "ABC" with "DEF"
Enter "ABC" and press .
Press to turn off the programmed thread
cutting ( ).
Press (Back key).
Press .
Press .
Press to turn it to .
X The stitching starting point is set to lower left
of the design.
Lower the embroidery foot, and then press
(Start/stop switch) to begin embroidering.
When embroidering is finished, trim the thread
leaving the end of the thread longer than usual.
Then reset the fabric in the embroidery frame,
in a position where you can embroider "DEF".
a Embroidery start position
b Embroidery end position
Enter "DEF" and press .
Press .
Press to turn it to .
X The stitching starting point is set to lower left
of the design.
a
b
