INSTALLATION
a) Attach the carry handle to the reel casing above the reel/hose mouth, using the screws provided.
b) The reel can be mounted in any position. The most common mounting positions are shown below. (Refer Fig 1,2,3,4)
If you choose the most popular positions (1) and (2) you should use the standard (8031-17) bracket.
If using positions (3) and (4) you will need the optional bracket (8031-16).
c) Fix mounting bracket in required location and position reel onto bracket. Brackets can be padlocked for additional security.
d) Connect supply hose to reel inlet allowing sufficient space for reel to swivel 180° on bracket.
Swivel rotation can be avoided (in the overhead position only) by adding the locking bracket (8031-18) supplied.
POSITIVE LATCH OPERATION
Pull out the hose to the required length.
Note: A clicking noise can be heard every half revolution of the drum. To latch the reel, allow the reel to slowly retract after hearing
the 1st, 2nd or 3rd click. To unlatch the reel, slowly pull out the hose until the clicking noise stops, then let the hose slowly retract
until the hose stopper rests against the reel mouth.
CAUTION
To prevent injury or damage occurring, do not let go of the hose during rewinding.
MAINTENANCE
This section details the step-by-step procedures that you may require for the general use and maintenance of your reel.
Please keep this instruction manual for future reference.
REMOVAL / REPLACEMENT OF INLET CONNECTION SIDE PLATE
a) Pull the hose out until it is fully extended and allow the hose to latch after hearing the 1st, 2nd or 3rd click.
b) Place reel on a clean bench with the inlet side plate (1) face up. Remove screw located at the edge of the inlet plate. Rotate plate
clockwise.
c) Swivel assembly and hose will come away attached to the inlet side plate.
d) To replace inlet side plate, suspend reel between your body and edge of bench. Reposition plate and turn counterclockwise and
relocate the side screw.
