RECOMMENDED TOOLS
1 Channel Locks
2 Adjustable Wrench
3 Plumbers' Putty or Caulking
4 Phillips Screwdriver
5 Flat Blade Screwdriver
6 Electric Drill & 1/4" Drill Bit
7 Tape Measure
1
2
3
4
5
6
7
INSTALL SPOUT ASSEMBLY;
Fig. 1
INSTALLATION
CAUTION
Turn off hot and cold water
supplies before beginning
10'
1
114mm
(4-1/2)
500mm
(20")
413mm
(16-1/4)
FINISHED
WALL
32mm
(1-1/4) DIA.
125mm
(4-7/8)
60mm
(2-3/8) MAX.
MOUNTING
SURFACE
(243mm)
9-9/16"
(127mm)
5"
(133mm)
5-1/4"
Roughing-in Dimensions
GENERAL DESCRIPTION:
Electronic faucet with proximity operation. Vandal
resistant solid brass construction single post
mounting. Operates on AC permanent power.
In-line strainer for solenoid is integral. Single inlet
3/8 compression, built-in checks, and flexible
stainless steel 16-1/4" reach inlet hose for spout
connection.
Note: All plumbing and electrical wiring must
be installed in accordance with applicable
codes, regulations and standards.
1. Insert WIRES (1), FLEX HOSE (2) and SPOUT
SHANK (3) through center hole of mounting surface.
Fig. 1.
2. Assemble "C" WASHER (4), STAR WASHER (5)
and LOCKNUT (6) onto threads of SPOUT SHANK (3)
from underside of mounting surface. Fig. 1a.
3. Align FAUCET and tighten LOCKNUT (6). Fig. 1a.
Note: 4" and 8" Deck Plates are available for other
installations, see page one for information.
Fig. 1a
Fig. 1
2
M965271
1
2
3
4
5
6
3
3/8" COMP.
81mm
(3-3/16)
(53mm)
2-1/8" DIA.
ELECTRICAL BOX OR
EQUIVALENT BY OTHERS
