© Adam Equipment Company 2004
10
• Press the [Cal] key (display shows ) then release the key to
save any changes to the current parameter, exit the setup menu, and
return to normal weighing mode.
• Press the [Units] key to save any changes to the current parameter
and move to the next setup parameter.
6.2 BUZZER ON/OFF
• The first option is to enable or disable the buzzer. The default state for this
parameter is buzzer on.
• The display will show
"
, where
=
for buzzer off,
=
for buzzer on.
• Press the [Zero/Tare] key to change the enabled state of the buzzer.
• Press the [Cal] key to save any change of buzzer state and return to normal
weighing.
• Press the [Units] key to save any change of buzzer state and move to the
next setup parameter, which is to set the automatic switch-off time.
• If the buzzer is enabled, it will sound to acknowledge a valid key press or
when an error condition is displayed.
6.3 AUTO SWITCH-OFF TIME
• The default value for this parameter is “
!##
” (auto switch-off disabled).
•
The display will show
!##$
, where
$
=
to
, representing the number of
minutes of inactivity, i.e. if no key is pressed for the specified auto switch-off
time displayed in minutes, the scale will automatically switch off. A value of
will disable the auto switch-off, while a value of
will cause the scale to switch
off approximately 9 minutes after the last key was pressed.
• Press the [Zero/Tare] key to change the auto switch-off time, with an
automatic roll-over from 9 to 0.
• Press the [Cal] key to save any change of auto switch-off time and return to
normal weighing.
• Press the [Units] key to save any change of auto switch-off time and move to
the next setup parameter, which is to set the enabled units.
