Filter
Top Products
GB-9
G
B
HB2302 / HBZ2602
6. Set up
BLOWER PIPE
•Align groove in blower pipe with projection on blower
housing.
• Slide the pipe onto the blower housing.
• Rotate the pipe clockwise to lock it into place.
• After the pipe is locked up to the housing, clamp the
pipe to the housing securely with the hardware sup-
plied with the unit. (Tightening torque : 3.4~4.4 Nm)
• Align groove in pipe end with projection on straight
tube and slide the pipe onto the straight pipe. Rotate
the pipe end clockwise to lock it into place.
INSTALLING SUPPORT HANDLE
• This handle is supplied with the blower.
• Fit the holes of volute and handle, tighten the screws.
• Be sure to tighten the screws straightly.
(1) Support Handle
(2) Holes
(3) Screws
(1) Blower housing
(2) Clamp
(3) Straight tube