Filter
Top Products
MAINTENANCE
English – 35
Winter use
Running problems can occur when using the machine in
the cold and snowy conditions caused by:
• Too low engine temperature.
• Icing of the air filter and carburettor.
Special measures are therefore often required:
• Preheat the intake air to the carburettor by using the
heat from the cylinder.
• Partly mask the air inlet on the starter to increase the
working temperature of the engine.
Fitting the winterising kit
Cut out a hole using a knife as shown.
Fit the winter cover in the cylinder cover.
Temperature 0°°
°°
C or colder:
Move the cover from position A to position B so that
preheated air from the cylinder can pass into the
carburettor compartment and prevent, e.g. the air filter
icing up again. When fitting the winter cover in position B
the centrifugal cleaning nozzle is blocked. This measure
requires the air filter to be cleaned more regularly.
Any maintenance other than that described in this
manual must be carried out by your servicing dealer
(retailer).
THIS SIDE
VISIBLE
537 21 05 XX