Filter
Top Products
so that saw chain does not turn. If idling speed is
too slow, turn the screw clockwise. (OP8)
4. Make a test cut adjust the H needle for best
cutting power, not for maximum speed. (OP8)
■ CHAIN BRAKE
The chain brake is a device designed to stop the
saw chain quickly when kickback occured.
The brake system equipped on the G310TS units
is designed to work automatically by sensing
reaction force. It can also be activated manually by
pushing the brake lever (front hand guard) down
forward.
A yellow cone popping up from the base of the
brake lever indicates that the brake is on.
Releasing the Brake
Pull the brake lever up toward the front handle until
it clicks. (OP9)
• When the brake worked, immediately release
the throttle lever and slow down the engine
speed. Running the engine at high speed while
braking the saw chain can cause clutch failures.
• Before starting the day's job, check the condition
of the brake system as follows:
1)Start the engine and grasp the handles
securely with both hands.
2) While pulling the throttle lever, slowly push
the brake lever (front hand guard) forward
with the back of your left hand.
3) Check that the brake works normally, then
release the throttle lever.
4) Pull the brake lever back to the OFF position.
NOTE
7. Operation
OP9
❲
13
❳