Zenoah G2500 OPS Chainsaw User Manual


 
G2500 / G2500 OPS
GB-11
G
B
It is very dangerous to run a chainsaw that mounts broken
parts or lacks any parts.
Before starting engine, make sure that all the parts includ-
ing bar and chain are installed properly.
STARTING THE ENGINE
Normal start
1. Fill fuel and chain oil tanks respectively, and tighten
the caps securely.
2. Continuously push the priming bulb until fuel comes
in the bulb.
3. Set the switch to “I” position.
(G2500 OPS)
Move the select lever to the machine back side
indicated by label until it is stopped, and then set
this lever to the recoil start mode.
4. Pull out the choke knob to the second-stage position.
The choke will close and the throttle lever will then
be set in the starting position.
One-push-start
(G2500 OPS only)
Use One-push-start after performing
warming-up by
Recoil Start in the status where the machine body is
securely fixed. You can not use OPS when the engine
is cold.
The starting performance of the engine depends on
the adjustment of the engine. Ask the distributor to
adjust the engine if possible.
Be careful not to set OPS in motion except when
starting the engine. If so, it may lead to serious injury.
1. Move the select lever to the front side of the machine
body indicated by label until it is stopped, and set
this lever to the One-push-start mode.
When restarting immediately after stopping the en-
gine, set the Choke knob in the first-stage position
(choke open and throttle lever in the starting posi-
tion).
Once the choke knob has been pulled out, it will not
return to the operating position even if you press
down on it with your finger. When you wish to return
the choke knob to the operating position, pull out
the throttle lever instead.
5. While holding the saw unit securely on the ground,
pull the starter rope vigorously.
Do not start the engine while the chain saw hangs in
one hand. The saw chain may touch your body. This
in very dangerous.
6. When engine has ignited, first push in the choke knob
to the first-stage position and then pull the starter
again to start the engine.
7. Allow the engine to warm up with the throttle lever
pulled slightly.
5. Operating the Engine
Choke
knob
When the engine is cool
When the engine is warm up
After the engine starts
WARNING
NOTE
WARNING
WARNING
Chain oil
Fuel
Select lever
Select lever
operating direction
Label
Throttle
interlock
Throttle
lever
Switch