Filter
Top Products
English
For safe operation and maintenance,
symbols are carved in relief on the
machine. According to these
indications, please be careful not to
take a mistake.
(a).The port to refuel the "MIX
GASOLINE"
POSITION: FUEL TANK CAP
(b).The direction to close the choke
POSITION: AIR CLEANER COVER
(c).The direction to open the choke
POSITION: AIR CLEANER COVER
1. CLEANER
Please inspect the cleaner
every
day for dirt. Please clean out any
dust that is found up to the
element on the carburetor side.
When rebuilding the cleaner, be
sure to follow the following order:
element → felt → element. If
dust remains on the cleaner
when it is used, the dust may
enter the engine, cause abrasion
in the pistons, and lead to engine
damage.
2. GEAR CASE
Please re-supply the gear case
with grease every 25 hours.
Grease must be added every
day if the unit is used in dusty
areas. Grease should be added
until the old grease emerges.
Dirty grease is a cause of
internal abrasion.
3. BLADES
Please replace the blades
if the
space between them becomes
0.7mm or more. This is because
dust may enter the gear case
and cause abrasion.
WARNING
2. SYMBOLS ON THE MACHINE
5