Filter
Top Products
14
[HTZ7500]
[CHTZ6000]
English
5. OPERATION
■ STARTING THE ENGINE
Keep the blades clear of
everything around It as they will
start moving upon the engine
starts.
1. Release the throttle lever and
make sure it is fully back. (F1)
2. Set the engine switch to the “I
(RUN)” position. (F1)
3. Push the primer pump until
overflown fuel flows out in the
clear tube. (F2)
4. Move the choke lever to the
closed position. (F3)
(1) Throttle lever (2) Engine switch
(3) Stop (4) Run
(5) Primer pump (6) Clear tube
(7) Choke lever (8) Open
(9) Close
5. Place the unit on a flat, firm place.
Keep the cutting head clear of
everything around it.
6. While holding the unit firmly, pull
out the starter rope quickly. (F4)
• Avoid pulling the rope to its end or
returning it by releasing the knob.
Such actions can cause starter
failures.
7. Move the choke lever downward
to open the choke. and restart
engine. (F3)
8. Allow the engine to warm up for a
several minutes before starting
opertion.
1. When restarting the engine
immediately after stopping it,
leave the choke open. (F3)
2. Overchoking can make the engine
hard to start due to excess fuel.
When the engine failed to start
after several attempts, open the
choke and repeat pulling the rope,
or remove the spark plug and dry
it.
■ STOPPING THE ENGINE (F1)
1. Release the throttle lever.
2. Move the engine switch to the
“O(STOP)”position.
If the engine doesn’t stop after
stopping the switch, close the choke
so that engine will stop after a little.
NOTE
NOTE
IMPORTANT
WARNING
(5)
F1
F2
F3
F4