Zenoah CHTZ2401L Trimmer User Manual


 
24
7. Operation
English
STARTING ENGINE
The cutting head will start moving upon the
engine starts.
1. Feed fuel into the fuel tank and tighten the cap
securely.
2. Rest the unit on a flat, firm place. Keep the cutting
head off the ground and clear of surrounding objects
as it will start moving upon starting of the engine.
3. Push the primer pump several times until overflown
fuel flows out in the clear tube. (OP1)
4. When the engine is cool, move the choke lever to
the closed position. (OP2)
(1) primer pump
(2) choke lever
(3) close
(4) open
(5) ignition switch
(6) RUN
(7) STOP
(8) throttle lever
5. Set the ignition switch to the “RUN” position.
Release the throttle lever and make sure it is fully
back. (OP3)
6. While holding the unit firmly, pull out the starter rope
quickly until engine fires. (OP4)
Avoid pulling the rope to its end or returning it by
releasing the knob. Such actions can cause starter
failures.
7. Move the choke lever to the open position. And pull
out the starter rope quickly to restart engine.
8. Allow the engine to warm up for a several minutes
before starting opertion.
1. When restarting the engine immediately after
stopping it, leave the choke open.
2. Overchoking can make the engine hard to start due
to excess fuel. When the engine failed to start after
several attempts, open the choke and repeat pulling
the rope, or remove the spark plug and dry it.
NOTE
IMPORTANT
WARNING
[HTZ2401]
[HTZ2401-CA]
[CHTZ2401]
[CHTZ2401-CA]
OP4
(1)
OP1
(2)
(4)
(3)
OP2
(7) (6)
(5)
(8)
OP3
(6)
(5)
(7)
(8)