Zenoah BK3410FL-S Brush Cutter User Manual


 
14
Do not pull out the starter rope up to its end, and do not
let the knob jump out of the right hand otherwise it may
not return to its original position.
5. After the engine has started, open the choke
gradually.
6. Allow the engine to run for 2 to 3 minutes to warm up.
STOPPING THE ENGINE
Stop the engine immediately in an emergency.
The blade rotates by inertia for a while after the
engine has stopped. Do not touch the blade until the
engine has stopped completely.
Do not touch the muffler or spark plug with bare
hands immediately after the engines has stopped.
Otherwise you may suffer burns because the muffler
and spark plug are extremely hot.
1. Return the throttle lever to the idling position.
2. Push the engine switch button. (OP5)
3. Close the fuel cock.
(1) Engine switch button
If you stop the engine while keeping the revolution
speed high, the engine could become damaged. Return
the throttle lever to its original position and reduce the
engine speed before stopping the engine except in an
emergency.
EQUIPPING THE SHOULDER STRAP (OP6)
1. Hold the main pipe with your right hand. Hang the left
strap on your left shoulder.
2. Change your hand to hold the main pipe with your left
hand. Hang the right strap on your right shoulder.
IMPORTANT
WARNING
IMPORTANT
position and pull out the starter rope repeatedly, or try
the starting operation again after removing the spark
plug and drying the electrode.
1. Open the fuel cock. (OP2)
2. Move the choke lever to the closed position. (OP2)
(1) Fuel cock
(2) Close
(3) Open
(4) Choke lever
(5) Close
(6) Open
When restarting immediately after stopping the engine,
move the choke lever to the open position.
3. Set the throttle lever to the idling position. (OP3)
(1) Idling
(2) Full throttle
When restarting immediately after stopping the engine,
move the throttle lever to the idling position.
4. Place the machine on a flat and firm place, and make
sure to keep the blade clear of everything around it.
Then, holding the main pipe with your left hand, put
your right foot on the frame, and pull out the starter
knob with your right hand quickly. (OP4)
NOTE
NOTE
OP5
7. Operation
OP2
OP3
OP4