Zenoah BCZ2602DL Brush Cutter User Manual


 
GB-14
BCZ2602DL
AIR FILTER
The air filter, if clogged, will reduce the engine perfor-
mance. Check and clean the filter element in warm,
soapy water as required. Dry completely before in-
stalling. If the element is broken or shrunk, replace
with a new one.
FUEL FILTER
When the engine runs short of fuel supply, check the
fuel cap and the fuel filter for blockage.
SPARK PLUG
Starting failure and misfiring are often caused by a
fouled spark plug. Clean the spark plug and check
that the plug gap is in the correct range. For a re-
placement plug, use the correct type specified by
ZENOAH.
REPLACEMENT PLUG IS A NGK CMR7A.
9. Maintenance
Every Every Every
25 50 100
System/components Procedure
Before
hours hours hours
Note
use
after after after
fuel leaks, fuel spillage wipe out
fuel tank, air filter, fuel filter inspect/clean ✔✔ replace, if necessary
see adjusting replace carburetor
idle adjusting screw
idling speed if necessary
clean and readjust GAP: .025 in (0.6 ~ 0.7 mm)
spark plug
plug gap replace, if necessary
cylinder fins, intake air cooling vent
clean
muffler, spark arrester, cylinder exhaust port
clean
throttle lever, ignition switch check operation
replace if
cutting parts
something’s wrong
gear case grease
screws/nuts/bolts tighten/replace ✔✔not adjusting screws
debris guard make sure to attach
BLADE
• Check the blade and the fasteners for looseness,
cracking, or bending.
• Check the cutting edges and reform with a flat file.
(A) Saw blade
(B) 8-teeth blade
(C) 3-teeth blade
Point :
1. Keep the end corner sharp.
2. Round the root of the edge, using round file.
3. Do not use water when using a grinder.
IMPORTANT
• It is recommended that filing should be done by
professionals.
• Especially regarding filing the saw blade, Leave it to
the professionals.
WARNING
Make sure that the engine has stopped and is cool
before performing any service to the machine. Con-
tact with moving cutting head or hot muffler may
result in a personal injury.
9. Maintenance
ENGINE
SHAFT
0.6~0.7 mm
(1) Fuel filter
(1)
(1)
(1) Air filter