Filter
Top Products
GB-9
G
B
INSTALLING HANDLE
• Install the handle to the shaft tube and clamp.
INSTALLING DEBRIS GUARD
• Attach the guard to the bracket on the main pipe and
fix it with 2 screws.
6. Set up
INSTALLING CUTTING HEAD
1. While locking the gear shaft, by inserting the supplied
tool into the upper holder on the gearbox, loosen and
remove the hexagon nut (left-handed).
2. Then screw in the cutting head to the gear shaft over
the holders. Hand-tighten it securely.
BALANCE UNIT
1. Put on strap and attach unit to strap.
2. Slide clamp up or down until unit balances with head
aparting from the ground when using it.