Filter
Top Products
20
Fuel Valve
FIG - 9
OPERATING INSTRUCTIONS
Key Switch
Throttle
Choke
Blade
Engagement
FIG - 8
Hour Meter
Hour Meter
Key Switch
Key switch is located on the console. Used to start
the machine. NOTE: Do not run the starter for
more than 5 seconds at a time. If the engine will
not start, wait about 10 seconds before trying
again. FIG - 8
Fuel Shut Off
Fuel shut off valve is located at the right rear of the
seat. The valve has three positions a right tank, left
tank and center is the off position. FIG - 9.
Tracking
The tracking knob is located in front of the left con-
trol lever. Rotating this knob allows fine tuning ad-
justments so that the machine tracks straight with
the drive levers in the full forward position.
Rotate the knob clockwise (as viewed from the
operating position) to increase the speed or coun-
terclockwise to decrease the speed on the left
control lever. Example: If control levers are full for-
ward and the unit turns to the right, turn the track-
ing knob counterclockwise to decrease the speed
on the left control lever.
Pump Release Valves
Pump release valves located at the right front cor-
ner of the pumps. Used to release the system so
the machine may be moved by hand when not
running. Tilt seat forward to gain access to the
pumps. Use a 5/8” wrench to open valve. NOTE:
Only rotate valve 1/4 turn to release system.
The hour meter displays the total operating time.
It will flash CHG OIL (Change Oil) at 50 hour inter-
vals. The flash duration is one hour before and
one hour after the interval. The CHG OIL icon will
come on and shut off automatically. The hour
meter can not be manually reset.