Filter
Top Products
12
OPERATING INSTRUCTIONS
STARTING AND OPERATION:
1. Operator must be sitting in the seat. Engage park brake, blades off and place the motion
control levers in the neutral slots. (See figure 6)
2. Adjust throttle to 1/2 and set choke (if needed) turn key and release as soon as engine
starts.
3. Release park brake.
4. Close motion control levers.
5. Engage blades and set RPM to maximum. NOTE: Be sure all persons are clear of area
before engaging the blades. To prolong spindle bearing and belt life engage and disengage
blades at approximately 1\2 throttle
Figure 6
IMPORTANT !
WARNING
1. Mow only in daylight or good artificial
light.
2. Do not operate the mower in wet grass if
possible.
3. Mow up and down slopes. Use caution
when mowing or turning on slopes. Always
turn to the downhill side. Do not mow ex-
cessively steep slopes ( mower may tip
over and cause injury or death).
4. Use caution when backing up.
5. Stop the blades when crossing surfaces
other than grass; or when traveling to and
from the area to be mowed.
6. Do not operate in an unsafe manner. Use
caution when making maneuvers. Sharp
cornering, turning, & slopes can be unsafe
if caution isn’t used.
Sharp, high speed, manuevers on
pavement or asphalt may reduce the life
of the traction drive components. Slow
down when manuvering, loading or
unloading especially on pavement or
asphalt.
Do not alter any drive component,
including pumps, motors, wheels, rims
and tires.