Filter
Top Products
10
ADJUSTMENTS
FRONT DECK BELT ROUTING:
FIGURE 3
DECK BELT
FIXED IDLER
PULLEY (TALL)
RIGHT DECK
PULLEY
SPRING
FIXED IDLER
PULLEY
CENTER DECK
PULLEY
SPRING LOADED
IDLER ARM
ELECTRIC CLUTCH
ON THE ENGINE
LEFT DECK
PULLEY
MOWER DECK LEVELING:
1. Position mower on a flat surface and stop engine.
2. Check the tire pressure of all four tires. Inflation should be 15 psi.
3. Place two 2x4’s on edge under the blades from side side and lower the deck down onto the
2x4’s.
4. Place the height of the deck in the 3 1/2" cutting height position.
NOTE: make sure deck lift blocks are tightly bolted to the frame .
5. Adjust the four upper chain bolts up until the chains are tight.
6. Check chains for equal tension. If unequal, adjust upper chain bolt in slot.
7. Remove 2 x 4’s and measure from the cutting edge of the blade to a flat surface to check
deck cutting height.