Filter
Top Products
11
ASSEMBLY
Blower/Drive Kit
1. Open the drive kit box and remove all of
the components.
2. Place the deck in the lowest cutting
height.
3. Remove the right side belt shield from the
deck.
4. Remove the deck belt from the right side
pulley.
5. Remove the deck pulley, but keep the
hardware at hand for re-installation.
Note: When the deck pulley is removed, the
spindle can fall out of the cutter housing
assembly. Be sure to secure the bottom of the
spindle so that this does not happen.
6. Place the double pulley on the cutter
housing spindle usingthe original washers,
but replacing the 7/16” bolt with the longer
7/16 x 2 1/2” bolt with zerk. Torque to 45 ft/
lbs.
7. Re-install the deck belt.
8. If any weld beads or the edge of the deck
top protrude past the right end surface of
the deck, these must be ground back to allow
the blower assembly to fit up flush against
the end of the deck.