Filter
Top Products
7
Figure 5
CUTTING HEIGHT
Step 7
For rough or uneven
lawns, move the height
adjustment lever to a
higher position. This
will help prevent scalp-
ing of the grass.
Drive Control
Step 8
For some people the
drive control may not
be in a comfortable
position. You can
adjust the handle by
tightening the adjust-
ment wheel.
3
Setup and
Adjustment
Figure 6
Figure 7
Never operate mower
unless the hooks on
the grass catcher are
firmly seated in the
slots on the handle
bracket assemblies,
and the rear dis-
charge door rests
firmly against top of
the grass catcher.
WARNING: Never operate mower
unless the hooks on the grass
catcher are firmly seated in the
slots on the handle bracket as
-
semblies, and the rear discharge
door rests firmly against top of
the grass catcher.
6. Follow steps below to install the mulching baffle:
a. Lift the rear discharge door and lift the grass
catcher up and off of the pivot rod, if installed.
b. Insert the mulching baffle as shown in Figure 5
and release the rear discharge door.
7. The cutting height adjustment lever is located above
the rear left wheel. See Figure 6.
a. Pull the lever out and away from the mower.
b. Move the lever forward or back for desired cutting
height.
c. Release lever towards mower deck.
8. The adjustment wheel is located in the drive control
handle housing and is used to tighten or loosen the
drive belt. You will have to adjust the drive control if
any of the following happens:
a. The mower does not propel itself with the drive
control engaged.
b. The mower’s drive wheels hesitate with the drive
control engaged.
If either of these conditions occur, rotate the adjustment
wheel clockwise to tighten the cable and counter-clock-
wise to loosen the cable to adjust the drive control. See
Figure 7.
WARNING
B
A
Loosen
Ti
ghten
A
B
C