Filter
Top Products
5
WARNING - YOUR RESPONSIBILITY: Restrict the use of this power machine to persons who read,
understand and follow the warnings and instructions in this manual and on the machine.
NOTE: Not all safety labels shown may apply to your chipper shredder vacuum.
SECTION 2: ASSEMBLING YOUR CHIPPER SHREDDER VACUUM
IMPORTANT:
This unit is shipped without gasoline or oil
in the engine. Be certain to service engine with gasoline
and oil as instructed in the separate engine manual
before operating your machine.
NOTE: Reference to right or left hand side of the
chipper shredder vacuum is observed from the
operating position.
Removing Unit From Carton
• Remove staples, break glue on top flaps, or cut
tape at carton end and peel along top flap to open
carton.
• Remove loose parts if included with unit (i.e.,
operator’s manual, etc.)
• Cut along corners, lay carton down flat, and remove
packing material.
• Roll or slide unit out of carton and check carton
thoroughly for loose parts.
Loose Parts In Carton (See Figure 1)
• Handle Assembly
• Bag
• Blower Chute (If Equipped)
Disconnecting Spark Plug Wire
Before setting up your chipper shredder vacuum,
disconnect the spark plug wire from the spark plug and
ground to a stud on the engine.
Figure 1
Bag
Wing
Nuts
Wing
Nuts
Carriage
Screw
Upper
Handle
Lower
Handle
Blower Chute