Filter
Top Products
9
Figure 7
Recoil Starter
The recoil starter is attached to the right lower handle.
Stand behind the unit and pull the recoil starter to start
the unit. See Figure 7.
Blade Control Handle
The blade control handle is located on the upper handle
of the mower. The blade control handle must be
depressed in order to operate the unit. Release blade
control handle to stop engine and blade. See Figure 7.
WARNING: This blade control mechanism
is a safety device. Never attempt to bypass
its operations.
Caster Lock
WARNING: When operating mower on
hills, front wheels should be locked in the
straight ahead position.
The casters can be locked in a straight ahead position
or can be left to swivel freely.
• Lift and place the lock pins in the larger holes to
lock the wheels for straight-ahead operation.
• Place pins in smaller holes to allow casters to rotate
freely for turning.
Cutting Height Adjustment Lever
The cutting height adjustment lever is located above
the left rear wheel. To adjust the cutting height, refer to
the Adjustment Section in this manual. See Figure 7.
Drive Clutch Control (820 Thru 829)
The drive clutch control is located on the upper handle.
Squeeze the drive control to engage the drive system.
Release the clutch control to disengage the drive
system. Release the clutch control to slow down when
approaching an obstacle, making a turn, or stopping.
See Figure 7.
Engine Controls
See the separate engine manual for the location and
function of the controls on the engine.
Stopping Engine
• Release blade control handle to stop the engine
and the blade.
• Disconnect spark plug wire and ground it to the
post on the engine.
SECTION 5: OPERATING YOUR LAWN MOWER
WARNING: Keep hands and feet away
from chute area on the cutting deck. The
operation of any lawn mower can result in
foreign objects being thrown into the
eyes, which can result in severe eye
damage. Always wear safety glasses or
eye shields.
NOTE: For shipping purposes your mower is set with
the wheels in a low cutting height position. For best
results raise the cutting position until it is determine
which height is best for your lawn. See the adjustment
section for details.
Recoil
Starter
Drive Clutch
Cable
Blade Control
Handle
Caster Locks
Cutting Height
Adjustment Lever
Model Series 820 Shown