Filter
Top Products
6
SECTION 3: ASSEMBLING YOUR SNOW THROWER
IMPORTANT:
After assembly, service engine with
gasoline, and check oil level as instructed in the
separate engine manual packed with your unit.
NOTE:
References to right or left side of the snow
thrower are determined from behind the unit in the
operating position.
Unpacking
• Remove staples or break glue on the top flaps
of the carton. Remove any loose parts included
with unit (i.e., operator’s manual, etc.).
• Cut corner’s and lay end of carton down flat.
Remove packing material.
• Roll unit out of carton. Check carton thoroughly
for loose parts before discarding.
Tools required for assembly
• Pair of Pliers
• Two adjustable wrenches
Loose parts in carton See Figure 1
Figure 1
A (2) Handles (Right and Left)
B (1) Handle Panel Assembly
C (1) Speed Selector Plate
D (1) Shift Lever
E(1)Chute Directional Control Ass’y.
F (1) Chute Assembly
(1) Hardware Pack
A
C
D
E
F
B