Filter
Top Products
13
Blade Mounting Torque:
Blade adapter bolts: 120 in.lbs. minimum, 150
in.lbs.maximum Center bolt: 450 in.lbs. minimum, 600
in.lbs. maximum.
Replacing Drive Belt
• Remove two shoulder screws securing the front
drive cover to the mower deck. See Figure 13 .
• Press inward on the sides of the front drive cover
and release the tabs that secure the front drive
cover to the height adjuster brackets. Remove drive
cover from the mower.
• Using a torx wrench, loosen the screw holding the
belt tension spring to the transmission. See Figure
13 . Do not remove the screw completely. As you
loosen the screw, the tension on the belt will be
released.
• Push the transmission up a little and slide the belt
off the transmission pulley.
• Lift the mower to access the belt from the underside
of the mower.
Figure 13
• Slide the belt off the engine pulley and around the
blade. See Figure 14 .
• Replace with the new belt, working around the
blade. Make sure the belt is firmly seated on the
engine pulley while pulling from the other side and
sliding it around the transmission pulley.
• Put the mower down with all four wheels firmly
placed on one level.
• Tighten the screw, loosened earlier, to secure the
belt tension spring to the transmission, and
reassemble the front drive cover.
Figure 14
Replacing Rear Flap
• To remove rear flap, cut off the flat end of the wire
rod which secures it to the deck. See Figure 15 .
• Attach the new flap and new rod to deck, bending
the ends of the new rod over to secure to deck.
Figure 15
Adjusting Handle Height
Your mower is shipped with the handle in the higher
height position.
• Remove the starter rope from the rope guide.
• Remove the upper handle by removing the hand
knobs and carriage bolts. Lay the upper handle out
of the way, being careful not to bend or kink cables.
• Remove the hairpin clips from the weld pins on the
handle brackets. Refer to Figure 5 .
• Remove the carriage bolts and wing nuts from the
handle brackets. Press out on the legs of the lower
handle. Remove lower handle from the mower.
WARNING: As always, use a thick piece of
rag to handle the blade while sliding the belt
around it. Make sure the engine does not start
at all while doing this job.
Loosen this screw
Shoulder
Shoulder
Screw
Screw
Front Drive
Cover
Belt
Transmission
Engine
Pulley
Left Front
Wheel
Right Front
Wheel
Handle
Bracket
Handle
Bracket
Rear Discharge
Door
Rear
W
i
r
e
R
o
d
Flap