Yard Machines 2N1 Snow Blower User Manual


 
Replacing Belt
Remove the belt cover by removing the five hex screws 1.
that secure it to the frame. See Fig. 7-1.
Remove the belt by grasping it from the bottom of the 2.
auger pulley and pulling outward.
NOTE: Push down on the idler puller to release the belt
from under the belt keeper. See Fig. 7-1.
To replace the belt follow these instructions and refer to Fig. 7-2:
Push down on the idler pulley.1.
Position the belt on top of the auger pulley and under the 2.
belt keeper.
Route the belt around the engine pulley.3.
Push the belt over the bottom of the auger pulley.4.
Reinstall the belt cover removed earlier.5.
Idler Pulley
Belt Keeper
Hex Screws
Figure 7-1
Figure 7-2
Engine Pulley
Auger Pulley
1
4
3
2
Service
8
18