Filter
Top Products
13
ON
OFF
Spindle and Drive Pulley Split hub R&R
• Remove 2, ¼” bolts from split hub and install in threaded holes in hub.
• Slowly tighten each bolt, alternating as you tighten bolts against the pulley.
• The hub will separate from the pulley.
• Replace grade 8 bolts and install in reverse order using the assembly holes to tighten hub onto pulley
and spindle shaft.
Digital Hour Meter
The Stander RH is equipped with a digital hour meter. Refer to operating/reset instructions below.
The programming specified is:
Default display: Hours
Press once (TMR1): Timer 1, press for 3 sec to reset
Press twice (TMR2): Timer 2, press for 3 sec to reset
Press three times (svc ENG): Will display time remaining until
next service point, hold down to reset. The first interval is 8hr,
thereafter 100hr. Beginning 5hr before service point the
meter will flash “svc ENG, in [remaining hours]” every 5 sec.
Shut off engine: Will display how many times the engine has
started.
Fuel System / Shut-Off Valve
The fuel shut-off valve and fuel gauge is located on top of the fuel tank. The valve should be in the “OFF”
position at all times when the mower is not in use. Do Not fill the tank completely.
Assembly
hole
Threaded
Removal
holes
Assembly
hole
Tightening
will
separate the hub
from the pulley