Filter
Top Products
16
Bleeding Air from the Hydraulic System
Whenever servicing the hydraulic system, it is of
the utmost importance to keep any dirt or debris
from getting into the system. Clean off all parts
before disassembly and assembly. When any of
the hydraulic parts are disconnected or removed or
when the oil is changed, air must be bled from the
system. If air is entrained in the system, loss of
power, excessive heat, and damage to the
hydraulic pumps may occur. First, make sure the
oil level in the reservoir is correct. The oil should
be level with the bottom threads of the oil level
port. Use fully synthetic oil: Mobil1 15W-50. With
the bypass valves open and the engine running,
slowly move the control levers back and forth five
or six times. Now close the bypass valves and
with the engine running, slowly move the control
levers back and forth five or six times. It may be
necessary to repeat the above steps until all the air
is purged and the rear wheels are turning at
normal speed. After purging is complete, adjust
the oil level in the reservoir if necessary.
Battery Service
The battery is 12 volts and is a maintenance free
battery. Charge the battery only if it will not start
the mower properly. Remove the battery from the
mower before charging. Follow the instructions of
the battery charger for proper and safe charging of
the battery.
Cleaning the Mower
The underside of the mower deck should be checked
and cleaned twice daily and more often if the grass
being mowed is lush or wet. The entire mower
should be cleaned daily at the end of the work day.
Cleaning should be done with a leaf blower or low-
pressure compressed air. Wash with water only
when necessary and do not use a pressure washer
or nozzle as the water can enter bearings and
electrical connections causing an electrical short,
rust and corrosion. When washing with water, avoid
spraying near the hydro cap and do so when the unit
has cooled down. Washing a hot machine can
cause various unseen system damage. If water is
used for cleaning, immediately dry it with a leaf
blower or low-pressure compressed air and run with
blades engaged for approximately 10 minutes. Once
the wash is complete, always lubricate and grease all
applicable areas.
Fuel Evaporation System
All Wright Sport X’s need to have this mandatory
feature.
• Do Not alter or remove.
• Do Not fill past the “Max Fill Level” line
shown in Figure below.
• Over-filling could result in clogging the roll-
over vent and/or contaminating the purge
canister.
• The vapor canister is located under the
dash.
• Inspect and clean dust filter every 500 hrs
or annually.
Dust Filter
Vent /
Purge
To
Tank