Filter
Top Products
10 Hydraulic Installation
MAN0788 (1/16/2008)
58025 HOSE KIT
General Description
These set-up instructions are for operating the
LUP126-2 or LUP132-2 loader using the tractor
hydraulic rear remote control couplers. To use this
hydraulic connection, the tractor must be equipped
with two hydraulic levers and four tractor hydraulic
couplers shown in Figure 11.
NOTE: Hydraulic couplers for connection to tractor
are NOT INCLUDED with this hose kit but are avail-
able as service parts.
Not all parts supplied in hose kit are used for this
application.
Figure 11. Tractor Hydraulic Couplers
Connect and Route Hoses
1. Attach a 90-degree elbow (2) and male quick cou-
pler (3) to each loader supply hose (1).
2. Connect loader supply hoses to loader feedlines
as shown in Figure 12.
3. Route hydraulic hoses along loader mount, under
the right side of operator's platform, and over the
rear axle.
NOTE: Be sure to avoid contact with three-point
linkage, brake pedals, and other moveable tractor
components.
NOTE: Hoses must be routed so that they are not
pinched, bent sharply, or chafed during operation.
Hoses must not interfere with any tractor control
operation or contact any moving parts.
1. 53670 Hose, 150" x 3/4 JICM x 3/4 JICM
2. 313053 Elbow, 3/4 JICF x 1/2 NPTM 90°
3. 66511 Quick coupler, male 1/2"
(not supplied in kit)
Figure 12. Loader Feedline Identification