Filter
Top Products
Assembly 15
MAN0101 (Rev.10/15/2004)
ASSEMBLY
DEALER SET-UP INSTRUCTIONS
Assembly of this equipment is the responsibility of the
Woods dealer. It should be delivered to the owner com-
pletely assembled, lubricated, and adjusted for normal
operating conditions.
In most cases the Super Turf Renovator is shipped
completely assembled from the factory. The seed box
is an option that can be added to the Super Turf Reno-
vator at a later time if desired.
Install Seedbox
1. Place seedbox on top of renovator mounting
saddles.
2. Install four carriage bolts (18) from underneath
saddles and secure with flanged lock nuts (19).
See Figure 11.
3. Do not tighten until all adjustments are completed.
18. 5/8 NC x 1-1/2 Carriage bolt GR5
19. 5/8 NC Flange lock nut
Figure 11. Seedbox Hardware Installed
Install Drive Sprocket
1. Place washers (12), sprocket (13), and lock nut
(15) on the left side of rear roller drive axle (Figure
12).
2. Do not tighten nut at this time.
NOTE: When properly torqued, the hex lock nut drives
the seedbox roller chain. Disengage the seedbox chain
when not in use by backing off a 1/4 turn on the lock
nut.
12. 3/4 Flat washer
13. Drive sprocket, 18T w/bearing
15. 3/4 NC Nylok Jam nut
Figure 12. Drive Sprocket Installed
Install Idler Bracket
1. Remove hex nuts (31) and hardened flat washers
(30) from cap screws securing the spring bracket to
the renovator. See Figure 13.
2. Place idler bracket assembly over cap screws and
install washers (30) and hex nuts (31) previously
removed. See Figure 14.
30. 5/8 Hardened flat washer
31. 5/8 NC Hex nut
Figure 13. Spring Bracket and Hardware
DP11
18
19
DP10
12
15
13
12
DP12
3130
3130