Filter
Top Products
Assembly 11
MAN0118 (Rev. 12/23/2004)
ATTACHING SWEEPER TO TRACTOR
(Figure 4)
Replace existing step on 2-way angle mount of tractor
with shorter step supplied with sweeper. Remove cotter
pin on end of step rod and slide out. Install shorter step
and replace rod and cotter pin. Keep existing step for
use with mower decks if desired.
Attach sweeper mount (2) to the holes in tractor mount-
ing bracket (1) that allow the broom mount assembly
to set in a level position.
Secure mount to tractor by rotating attaching pins (3)
rearward to lock pins into place.
Connect the PTO sleeve and yoke to rectangular shaft
of sweeper mount. Attach PTO to shaft on tractor.
Refer to instruction in SweepsterR manual and make
sure the broom is level prior to operation.
2-WAY ANGLE WIRING INSTRUCTIONS
(Figure 5)
Position the wiring harness along the right mounting
arm of mount, under step, and through the hole in the
tractor front panel, directly below the right steering
lever. The wiring harness may be separated at the con-
nector (A) to ease installation. Disconnect the wiring
harness from the tractor at this point when removing
the broom from the tractor. Rear section of wiring har-
ness may remain on tractor at all times.
Secure relay and connector to tractor frame using plas-
tic wire ties through holes near seat hinge.
Attach T-tap securely to a purple wire, directly behind
the ignition switch, inside the console. Connect the
short black pigtail to the T-tap and install a 7.5 amp
auto fuse into the slot. Route the black harness lead
into the console through the hole near the seat hinge.
Connect the pigtail to the black lead from harness.
Attach eyelet of green wire to negative post of battery.
Attach eyelet of red wire with fuse holder to positive
post of battery.
Route wires and secure them with wire ties so they are
clear of all moving parts of the tractor.
When using the broom for de-thatching, bolt the caster
wheel assemblies to each side of the broom head
using existing bolts in the broom head. The broom's
height can be adjusted by placing spacers on wheel
forks above or below the fork housings.
Figure 4. Attaching Sweeper to Tractor
1. Tractor mount
2. Sweeper mount
3. Attaching pin
3
2
1
CD4648A