Filter
Top Products
42 Assembly
MAN0571 (Rev. 6/15/2007)
DS1260 & DS1440 Pull-Type Assembly
(Continued)
INSTALL CV DRIVELINE (OPTIONAL)
Install Driveline (Figure 30)
1. Coat input shaft of gearbox with a light coating of
grease.
2. Attach slip clutch on driveline (6) to input shaft of
gearbox. Tighten cap screws (14) and lock nuts
(15).
3. Attach rear tether chain on driveline to clip on
plastic gearbox shield.
Install H-Frame
1. Attach H-frame mounting bracket (13) to cutter
frame with carriage bolts (23), washers (24) and
lock nuts (21).
2. Place H-frame (2) over bracket and align holes.
3. Secure H-frame to bracket using cap screw (18),
two sleeves (3), two cup washers (4), and lock nut
(19).
Attach Driveline to H-Frame
NOTE: Select holes in H-frame that will allow driveline
to run level. Refer to Operation section for driveline
height. Final adjustment will be necessary when cutter
is attached to the tractor.
Place driveline bearing carrier between H-frame (2)
and secure with clevis pin (5) and cotter pin (20).
Install CV Drive
1. Slide rear yoke of CV driveline (1) over shaft of
driveline (6) and align with notch on shaft.
2. Secure drives together using cap screw (16) and
lock nut (15).
Install Drive Shield & Hose Holder
1. Attach drive shield (10) to driveline carrier bearing
using two cap screws (26) and lock washers (25).
2. Attach hydraulic hose holder (12) to the top hole in
H-frame (2) with cap screw (17), spacer (11), and
lock nut (21).