Filter
Top Products
37
WOODS
X
B
FIGURE 1
PARKING BRAKE
FOR 61" MODELS
NOTE: There are 2 brakes, 1 on each transaxle.
The parking brake should keep the machine from
moving. To check the parking brake, park the ma-
chine on a level surface, open the bypass valves and
set the parking brake to ON. Attempt to move the
machine forward and backward by pushing it. If the
machine moves, adjust the parking brake linkage as
follows:
1. Move the machine to a at horizontal surface.
2. Grip the ats on the brake rod A. Tighten nut
B on the brake rod until you run out of threads.
See Figure 1 for detailed view.
3. Move the parking brake handle to the OFF
position.
4. Loosen nut X.
5. Hold brake arm in the OFF position as shown in
Figure 2.
6. Adjust linkage rod U until formed end of rod
meets brake arm hole in the OFF position.
7. Insert cotter pin into formed end of linkage rod U.
8. Tighten nut X.
9. Repeat Steps 1-8 on the opposite side.
FIGURE 2
ADJUSTMENTS
TIGHTEN UNTIL YOU
RUNOUT OF THREADS