Filter
Top Products
40
WOODS
NOTE: Always use WOODS. replacement belts, not general purpose belts. WOODS, Inc.
belts are specially designed for use on this mower and will normally last longer.
CUTTERDECK BELT
1. Remove oorplate.
2. Set the cutterdeck in a middle height-of-cut posi-
tion.
3. Use a 3/8" ratchet and extension to back
tensioning idler off to remove belt from idler.
Remove belt from cutterdeck pulleys.
NOTE: Use the 3/8" ratchet in the square hole A on
the idler.
4. Remove belt from clutch pulley.
5. Install the new belt by performing these steps in
reverse order.
NOTE: 61" cutterdeck may require tension spring
adjustment after belt installation. See Belt tension
3 SPINDLE DECK
BELT TENSION FOR 61" DECK
All belts are tensioned by spring loaded idlers and do
not require any adjustment except for the 61"
cutterdeck. Use the eyebolt to adjust the spring
length to be between 6 3/4" - 7 1/2" as pictured.
BELT REPLACEMENT